The Toyo Si-III Series Was Especially Designed For The Injection Molder in North America. The New Si-III Has The Muscle And Intelligences To Delivery The Pressure, Speed And Shot Size Necessary For Their Toughest Molding Requirements. We Dare You To Compare - Because "Your Best Bet Is Toyo".

PLCS-11 CONTROL

Intelligent yet easy to use control employs a RISC micro-processor to efficiently execute every machine movement. The injection unit responds 1.5 times faster than the conventional model. The advanced control can network with the servo-systems to reduce cycle time over conventional models which results in more molding cycles at the end of the day.

ULTRA RIGID "RASMA" MACHINE FRAME

The vibration-resident and ultra-rigid machine frame is the result of detailed CAE analysis of the traditional machine frame. The RASMA designed frame exhibits rigidity without adding weight due to its unique box construction.

ENERGY EFFICIENT

Fully electric injection molding machines consumes about one third of the electricity that hydraulic machines require. The new Si-III network servo system employed, the Si-III series can gain an additional 3 percent less electricity.

LOW NOISE POWER TRANSMISSION

By adopting low noise materials in timing belts and pulleys the noise level has been significially reduced. The timing belt also serves as a shock absorber that minimizes the impact on mechanical parts.

TWO COMPONENT "READY"

As factory standard the Toyo Si-III is "field ready" if a second injection unit is required when production needs change. The PLCS-11 control has the capacity to operate 12 axis. The machine base is pre-machined at the factory for easy of mechanical "bolt up".